Hydra - single pulley

in stock

New product

Before

44,90 € tax incl. / no tax (outside EU)

HYDRA – Facelift

SINGLE PULLEY FOR EXTENDING OUR PULLEY SYSTEMS

Refined look of surface and inscription – in brushed anthracite.



The single pulley Hydra can be used in the following scenarios:

  • As a 3:1 Multiplier pulley for CobraGrip, Cobra 1, Cobra 2 and Anaconda.
  • To extend the base pulley system of CobraGrip to 6:1, Cobra 2 up to 7:1 and Anaconda up to 13:1. One attached Hydra increases the working load of each system by 2 kN. Moreover, tensioning gets way easier by the higher mechanical advantage.
    If you buy one or several additional Hydras together with your Cobra 2, CobraGrip or Anaconda, we thread the our pulley in your preferred way! Please note your chosen configuration of the base pulley in the order process.
  • For redirecting the pulling direction. By attaching a Hydra to the anchor point with a seperate sling you can gain efficiency through a better angle. That is especially useful for longlines that are rigged high up (>1.5 m). Moreover it is useful to pull in another direction when there are obstacles in the way or if you want to take advantage of a slope.

The special surface is highly scratch resistant and gives the Hydra a brushed finish in decent anthracite. As an optic finish the One Inch Dreams logo is engraved with highly precise laser technology.

Working Load Limit (WLL) 4 kN (~900 lbf)
Minimum Breaking Strength (MBS) 8 kN (~1,800 lbf)
Material roller body: AL 7075, bearings: corrosion-resistant steel, all other parts: stainless steel
Weight 120 g (4,2 oz)
Recommended for Lowlines, Longlines, Tricklines, Waterlines & Rodeolines

Accessories

Customers who bought this product also bought: